Most kitchen sink problems come from grease build up, food waste, loose trap connections, worn tap parts or dry traps. Use strainers, avoid pouring fat down the drain, check under the sink monthly and call a plumber for repeated blockages or hidden leaks.
The kitchen sink works harder than almost any other fixture. It handles hot water, grease, food scraps, cleaning products and sometimes a dishwasher and filter as well. ALHUD Technical LLC is called to kitchen sinks in flats and villas across Abu Dhabi all year, and the faults repeat: slow drains, leaks under the cabinet, smells that return a day after cleaning, and taps that drip.
This guide goes through each problem, shows what you can safely try and explains when to stop and call a plumber.
Grease is the main culprit. Hot water carries cooking oil and fat down the drain, where it cools, thickens and sticks to the pipe wall. Food scraps, rice, coffee grounds and soap residue then catch on it, and the pipe narrows until water barely moves.
Prevention is much easier than clearing a solid blockage, so start with habits.
Begin with the gentlest method. Remove visible debris from the strainer. Pour a kettle of very hot water, not boiling water if your pipes are plastic, then add a little dish soap. Use a plunger with the overflow blocked with a wet cloth, and plunge firmly for several strokes. If you have a double sink, block the second drain first.
If that does not work, place a bucket under the trap, unscrew the slip nuts and clean out the trap by hand. Wear gloves and refit the nuts carefully so the seals sit flat. A hand drain snake can reach further along the pipe. Do not force it hard, since it can scratch or damage pipes.
Strong drain cleaners can heat and damage some pipes and seals, and they can splash and burn skin and eyes. They also make later work harder, because a plumber must then handle the chemical in standing water. If you do try a product, follow the label, wear protection, never mix products and tell the plumber afterwards.
Repeated use usually means the real problem is deeper in the pipe. A plumber can clear the line with a machine or inspect it with a camera to find the cause.
Open the cabinet and look with a torch. Wipe the pipes dry, then run the tap and watch for drips. Most leaks come from a short list of places.
Tighten gently by hand or with a light turn of a tool. Over tightening can crack plastic fittings. If the leak continues, replace the washer or fitting. Our plumbing repair team can trace and fix leaks, including those hidden behind cabinets.
A tap that drips wastes water and signals a worn washer, cartridge or O-ring. The US EPA runs Fix a Leak Week each year because small leaks add up to a lot of wasted water across a year. A drip you can ignore today is a bill you pay later.
Mixer taps often have a cartridge that can be replaced. Check the make and model, switch off the isolation valve and replace the part. If the tap body is corroded or loose, replacing the whole tap may be a better option.
Kitchen smells come from food residue and bacteria in the trap or pipe. They can also come from a dry trap, a blocked vent or a dirty food waste disposer.
Fragrance sprays hide a smell, but they do not remove the cause.
Restaurants and cafes often need grease traps to catch fat before it enters the sewer. A full trap overflows, smells and can cause blockages. Clean traps on a regular schedule and keep records. Check current rules with the relevant authority or the building management, since requirements for commercial kitchens can apply.
For homes, a simple habit works: wipe pans with paper before washing and bin the paper.
A weak kitchen tap can mean a blocked aerator, a partly closed valve or a problem with the supply. Unscrew the aerator and soak it in a descaling solution as the maker advises. If only hot water is weak, the water heater or its pipes may be the cause. Distance from the heater matters too. A small point of use heater can help where the tap is far from the main unit.
Many kitchens now have a disposer or a dishwasher plumbed into the sink drain. Both add places where things can go wrong. A disposer that jams, hums or smells needs care. Switch it off at the isolator, never put your hand inside and clear it using the maker's method, usually with a hex key at the base. Do not feed it fibrous food, large bones, oil or coffee grounds in bulk.
A dishwasher drains through a hose connected to the sink trap or a spigot. If the dishwasher leaves dirty water in the bottom, the hose may be kinked or the connection blocked. Check that the hose rises in a high loop under the worktop so waste water cannot flow back. Clean the dishwasher filter monthly. If water appears under the sink when the dishwasher runs, the hose connection may be loose or the hose worn.
A slow leak under the sink is easy to miss because it only wets the cabinet floor a little each day. Over months it swells chipboard and MDF, lifts laminate and encourages mould. In humid weather the damage spreads faster. If your cabinet floor is soft or stained, fix the leak first, then assess the board.
Replace swollen panels rather than painting over them. Consider a waterproof tray or a plastic liner under the sink, and keep cleaning products in a tray so spills do not soak into the board. Our carpenters can also replace damaged cabinet bases when you repair the plumbing.
Keeping these in one box turns many night time problems into a five minute fix. Do not buy cheap parts that do not fit, since a poor seal will leak again.
If your kitchen sink blocks again within days of clearing, or other fixtures gurgle when the sink drains, the problem may be in the main drain or the vent. Tree roots, broken pipes and heavy grease build up in shared stacks are possible causes. In a building, a blockage in a shared stack can affect neighbouring flats, so inform building management quickly.
A plumber can inspect the line with a camera, locate the problem and clear it with jetting or a machine. A camera report is useful evidence if you need to deal with the landlord or building management about who must pay.
Hard water leaves scale on taps, aerators and inside kettles and dishwashers. Scale narrows small openings, so flow drops and sprays go sideways. Soak aerators in a mild descaler and brush them gently. Wipe taps dry after cleaning to slow new deposits. If hot water arrives slowly, check the length of the pipe run and consider insulation or a small point of use heater near the sink.
Avoid harsh abrasives on chrome and brushed finishes, since scratches trap dirt and scale. Use a soft cloth and a cleaner suited to the finish.
If you are renovating, plan the plumbing with the cabinet layout. Decide the sink type, the tap, whether you want a disposer and where the dishwasher and filter will sit. Leave access for isolation valves and traps, and use good quality flexible hoses. Check that the drain has enough slope and a proper vent.
Ask the plumber to pressure test new pipes before the cabinets and splashback go in. A leak found at that stage costs little to fix. A leak found after tiling does not.
A good plumber explains the cause and the options plainly and gives you a written note of the work and the price.
Scrape plates into the bin before washing. Use a strainer and empty it daily. Keep a jar for cooking oil and bin it when full. Run hot water briefly after greasy dishes. Check under the sink at the start of each month. These small habits cost nothing and prevent most call outs.
If your kitchen sink keeps clogging, smells or leaks despite these steps, call ALHUD Technical LLC on +971 56 210 8748 and send a photo of the pipes under the sink on WhatsApp. We will tell you what is needed before we visit.
Grease, food scraps, coffee grounds and soap residue build up inside the trap and pipe. Repeated blockages can also point to a damaged or poorly sloped pipe.
They can damage some pipes and cause burns if they splash. A plunger, a snake or a plumber is usually a safer first step.
Common causes are food residue in the trap, a dry trap, a blocked vent or a dirty disposal. Cleaning the trap and flushing the drain often helps.
Loose slip nuts, worn washers, a cracked trap, a leaking tap connection or a split hose can all cause it.
Call one if the blockage returns quickly, if several drains are slow, if you smell sewage or if you cannot find a leak.
Need help? Call or message ALHUD Technical LLC on +971 56 210 8748. We will arrange a visit and confirm the scope and price before work starts.
Serving all Abu Dhabi areas, same-day appointments available